Product List
Grain-cleaning machines
- Sieve Air grain cleaning machine with pneumatic table 5XFZ-25 SC
- Machines for cleaning and sorting of grains 5 XFS-5C
- Machines for cleaning and sorting of grains 5 XFS-7.5C
- Machines for cleaning and sorting of grains 5 XFS-10C
- Machines for cleaning and sorting of grains 5 XFS-5CS
- Machines for cleaning and sorting of grains 5 XFS-7.5CS
- Machines for cleaning and sorting of grains 5 XFS-10CS
- Sieve Air grain cleaning machine with double separation (5 XFS-7.5FC)
- Зерноочистительная машина с камнеотборником 5XFS-3FA
- Зерноочистительная машина с камнеотборником 5XFS-3FAS
- Stone cleaners QSC-7
- Stone cleaners QSC-10
In the drum cleaner sieve cylinder consists of sections and each section can be used for screening, and for the removal of the coarse fractions gathering, and can perform both simultaneously. Depending on the needs of the cylinder design is easily changed. If necessary, all of the sieve can be installed with same size cell, which implies the maximum use of the drum surface. When calibrating sieve number of different sections in the cylinder determines the maximum number of division of fractions. In the flat-grain reshetnoj car must first pass through the upper sieve, before you will get separated on the bottom, thereby reducing throughput sposobnost.
Tilt and skorost.
Increasing the speed or incline on the flat sieve increases the bouncing grains and reduces the accuracy of the calibration. In the drum cleaner change the speed and incline increases product turnover, improves calibration accuracy, increases productivity by providing more management capabilities protsessom.
Applications for products that are difficult to sortirovke.
Versatility and a drum cleaner setup flexibility can be used for separation and calibration, even such difficult-to-clean products, such as very wet corn, etc. Also a drum cleaner can be considered as a multi-purpose cleaning machines -.. By replacing the sieve sections of one and the same installation can often be used for preliminary, primary treatment is then further final kalibrovki.
Separators drum is usually used in conjunction with mounted aspirator and allow to separate the light impurities, good grain from the crushed and large debris. At the same time the grain passes through a dual-action aspirator and the sieve drum. The aspirator initial product is distributed with a uniform layer, through which a stream of air. The amount of light particles entrained is controlled by changing the suction power. The heaviest of the impurities caught in the suction chamber are deposited in the sediment chamber and removed the screw. Direct access allows you, if you want to stop the operation of the unit. After aspiration, the grain goes to the sieve drum with interchangeable sieves. The first allows the sieve to remove the crushed grain and the subsequent skip conditioned product. Close out the trash at the end of the sieve drum. Consistent use of sieves with different diameter perforations provides the versatility of this equipment and the possibility of its use with any cereals with capacities ranging from 5 to 400 tons / chas.